The map has five triggers (not including hypers) and three locations. The locations are all invisible, so use the locations section on the left side treeview of SCMDraft to view them.
Look at the triggers and then take a note of what you expect to happen. The play the map and take a note a which does happen. Then post here explaining why what happens happens.
Attachments:
Post has been edited 1 time(s), last time on Jun 26 2009, 10:42 pm by scwizard.
None.
Where are the triggers and/or map?
None.
I believe posting the map would help.
None.
I forgot to press the "attach this" button >_>
None.
SDE, BWAPI owner, hacker.
Um? Is this some kind of joke? The triggers appear in the order I expect, so what's the point?
Order:
1) Location centered on "0x0 @ 1000x1000"
2) text "Unit X cord = 1000" doesn't display (tank is not in the location)
3) location centered on "0x0 @ 999x999"
4) text "Unit x cord = 999" displays (tank is in location)
5) text "I'm freaking out man!" displays
**next trigger loop**
6) text "Unit x cord = 1000" displays (the location is still on "0x0 @ 999x999")
If you enable Preserve Trigger on the first trigger (centering the location on x=1000), then "Unit X cord = 1000" will never display.
None.
Um? Is this some kind of joke? The triggers appear in the order I expect, so what's the point?
Well apparently it doesn't appear in the order morphling expects, nor in the order I expect.
If you center the inverted location, and then check to see if the unit is at that location. Why does it say "false" finish the trigger cycle and then say "true"?
None.
Um? Is this some kind of joke? The triggers appear in the order I expect, so what's the point?
Well apparently it doesn't appear in the order morphling expects, nor in the order I expect.
If you center the inverted location, and then check to see if the unit is at that location. Why does it say "false" finish the trigger cycle and then say "true"?
Lethal explained it to you. Basically, the inverted location stays at the 999 position after the first trigger loop, hence, in the second trigger loop, the display 1000 trigger will run.
None.
Order:
1) Location centered on "0x0 @ 1000x1000"
2) text "Unit X cord = 1000" doesn't display (tank is not in the location)
3) location centered on "0x0 @ 999x999"
4) text "Unit x cord = 999" displays (tank is in location)
5) text "I'm freaking out man!" displays
**next trigger loop**
6) text "Unit x cord = 1000" displays (the location is still on "0x0 @ 999x999")
If you enable Preserve Trigger on the first trigger (centering the location on x=1000), then "Unit X cord = 1000" will never display.
Oh that makes perfect sense. Whoops
None.