Okay, so my monitor messed up this morning.
It was fine for most of the day, then I booted up SC, and the screen darkened (considerably) and diagonal lines appeared on the screen, spacing about 1.5 in apart from each other (if that helps at all).
Right now, I've digged up my itsy-bitsy screen, but it works and that's what matters. I would like to get my other monitor back on the job, but I don't know how to fix it.
I've tried the following: resetting my comp, changing resolutions, turning the monitor off and on, living with it, and messing with the monitors settings (through the manual buttons below the screen.
None of it works. Any other idea's?
None.
Since you didn't mention checking (make sure every connection is there, I've had some weird shit happen when one or two prongs were missing) and tightening the cable between your monitor and computer, do that.
Do as Moose said, try updating your display drivers, and if problems persist, you may have a hardware problem with your gfx.
Do both monitors use the same type of connection?
None.
Do both monitors use the same type of connection?
Yes they do, and the 2nd one works just fine.
Since you didn't mention checking (make sure every connection is there, I've had some weird shit happen when one or two prongs were missing) and tightening the cable between your monitor and computer, do that
okay, tried it. It didn't make a difference. I took it out, replugged it, tightened it, still doesn't work.
Since the monitor I'm using now is smaller, I had to put my larger one back in to fix the resolution, and it still doesn't work.
None.
Since the other monitor works, I would rule out the graphics card. Also the cables being messed up sounds unlikely, but if possible, switch the cables around.
If it happened with SC was launched, did the resolution change back after you closed SC? I would try reinstalling display drivers then messing with the resolutions and frequencies some more, launching and closing SC. If that didn't work, I would try to beat the monitor with something if it is CRT.
None.
>be faceless void >mfw I have no face
Incidentally if you attach a magnet to the end of a drill and turn it on and move it by a CRT screen, it can clean up the flickers around the edges, but your problem sounds a bit different.
Red classic.
"In short, their absurdities are so extreme that it is painful even to quote them."
most have a degauss button on them...
Some monitors don't like to work at some resolutions. This is a defect, and is caused by the monitor being old. My brother's monitor won't go into 800x600. If you have multiple computers, switch out the defective monitor to the other computer to try to diagnose exactly what is wrong.
It's time to buy a new monitor, or figure a way around it. If the monitor works at its native resolution, play starcraft in a window (you'll have to download a mod for that).
"Parliamentary inquiry, Mr. Chairman - do we have to call the Gentleman a gentleman if he's not one?"
